Armaflex

INSTALLATION MANUAL
ARMA-CHEK D, ARMA-CHEK S, ARMA-CHEK R AND ARMA-CHEK T

Copyright ©, Armacell International GmbH
All rights reserved. No part of this book may be reproduced or transmitted in any form or by any means, digital or
mechanical, including photocopying, recording or by any information storage and retrieval system, without
permission in writing by Armacell International GmbH.
All statements and technical information are based on results obtained under typical conditions. It is the
responsibility of the recipient to clarify with us that the information is appropriate for the specific use intended by the
recipient. Please check with our Customer Service for further information.

1

Index

Application guidelines for Arma-Chek D,
Arma-Chek S and Arma-Chek R

Product range
Golden Rules when working with Arma-Chek D,
Arma-Chek S and Arma-Chek R
Health and Safety
Description of Tools
Correct use of Accessories
Application of pre-coated Arma-Chek D and Arma-Chek
S material
Application of tube material
General procedures
Straight pipes
Fabrication of bends
Bend with 45° angle
Segment bend with one middle part (2+1)
Segment bend with two middle parts (2+2)
Segment bend with three middle parts (2+3)
T-piece and offset-angle
Swept T
Y-tube
Pipe reducer
Insulation jacket covers (small valves / unions etc.)

2

4
5
6
7
8

11
11
13
13
13
13
14
15
15
16
16
16
16

Application of sheet material
General procedures
Valve coverings
Flange coverings
Pipework offset bend angle
Concentric reducer – equal
Eccentric reducer – flat back
Flat surfaces
Ductwork (rectangular, circular)
Vessels
Application of covering material
General Procedures
Cylindrical bodies (pipes, vessels, ductwork etc.)
Bodies with outer diameter < 500 mm
Bodies with outer diameter > 500 mm
Rectangular bodies (ductwork, vessels)
Ductwork bends and irregular shapes
Circular ductwork
Pre-fabricated fittings
Segmented Bends...